LED lamp electric (mains) | for curing LCA filler
LED lamp on mains is suitable for curing Light Curing Acrylic gel (most repairs are cured within 20 seconds for small damages with a diameter of < 1mm. For larger damages, > 1mm, keep the lamp on the damaged surface for 80 seconds, you do need to work the entire surface to get a full cure of the material.
For damages deeper than 1.5 mm, apply the filling material in layers and cure.
The LED lamp produces pure blue light in the optimum range (420nm.- 480 nm.) to cure Light Curing Acrylic filler in the fastest possible time.
The LED light-curing lamp stops if no action has been performed after 120 seconds. The buzzer gives a signal as soon as the LED light-curing lamp automatically shuts off to save the power source. The power source of the LED light curing lamp very small (less than -uA).
Installing the LED lamp
- Insert the supplied illumination rod through the orange eye protection shield and push it into the blue handle. (Although the blue light is not harmful, the shield is designed to make working with it more comfortable for your eyes.)
- Remove the red protection cap from the lighting rod.
- First, insert the European plug on the cord and connect the unit to a socket/mains and press the "P" button to start curing. The factory setting mode is 20 seconds. You can adjust the curing time by pressing the "T" button. The factory setting of the mode is 1, which gives full power to the lamp. This is the one you want, so you don't need to press the "M" button. There are 2 more modes on it but it is best to use only Mode 1.
Product specifications
Charger operating power: 10 VDC
Volt: AC 100-220 Vm 50-60Hz.
Battery voltage: 3.7-4.2V
Charging time: n/a, works on mains only
Optional working time: 10, 20, 30 and 40 sec.
Wavelength: 420-480nm
Light intensity: 1200-1500 mw/cm²
Light width: 8 mm
Deliverable: each
Social media