Pneumatic device for 400 ml. Stonefix tubes
Pneumatic device to process 2k Stonefix injection adhesive tubes/cubes of 400 ml. with. This should be connected to a small compressor. You can inject under slight pressure. The pressure is only necessary to make the injection adhesive flow.
The injection adhesive 2K Stonefix has such a viscosity that it is almost equal to the viscosity of water.
So thanks to the slight pressure, the injection adhesive 2K passes through the smallest microscopic openings under the tile. And this very far!
In practice, Stonefix has already gone as far as almost 3 metres under the floor. The device can process 2-to-1 and 1-to-1 tubes of 400 ml.
Stonefix's injection resin 2K is packaged in 2-to-1 tubes.
Product specification:
- Weight: 2.66 kg.
- Length: 48.6 cm.
- Maximum thrust force: 5.0 kN
- Tool material: cast aluminium and reinforced nylon
- Tube/cartridge capacity: 400 ml.
- Cartridge ratio: 1:1/ 2:1 / 4:1 / 10:1
- Air inlet: 1/4 in NPT
- Maximum working pressure: 6.8 bar/100 psi with epoxy injection adhesive do not use higher than 5 bar.
Deliverable: per piece
Social media