Stonefix 195 ml. Injection adhesive 2K DIY set | For loose-laid and hollow tiles
Stonefix is a professional injection epoxy adhesive on a 2-component basis, suitable for filling/fixing hollow and loose-laid floor and wall tiles, but also suitable for lacquered wooden floors, laminate and PVC floors. This without any chopping and breaking. The tube should be processed with a caulking gun. Excess material or ‘film’ (haze) on the floor is best removed with an alkaline-based Epoxy Residue Remover.
What are the main properties of Stonefix's injection adhesive 2K?
- The injection adhesive 2K is very strong.
- The injection adhesive 2K will cure after certain time (5 to 8 hours) depending on humidity and ambient temperature.
- The 2K injection adhesive is highly liquid. This means that the injection adhesive will pass through all openings under the tile. The smallest minuscule openings will be filled. You can almost compare it to water, so liquid.
- The injection adhesive 2K has great flexibility. It has greater flexibility than the floor tiles themselves.
- Good adhesion by injection under the floor only happens when the 2-components are mixed together. Because of the built-in system, you cannot empty the tube to the end. The tube contains 195 ml, you use 180 ml of this.
Tip: if you process several tubes, always use the same mixing tip to ensure you can process an extra 10 ml per tube.
Storage: between 5°C-20°C. Protect against frost.
Processing temperature: min. +5°C
At low temperature of the Stonefix 2K injection adhesive, it can be warmed up by e.g. placing it for 10 minutes in a bucket with warm water.
Always close tightly.
Additionally, always apply the cap in the same way, a to a and b to b, otherwise you will have mixing of the 2-components and it will get stuck.
Usage:
For tiles glued (best is double glued) with tile adhesive, usage is between 1 and 2 litres of injection adhesive per m².
For tiles laid in cement/mortar, usage is between 3-5 litres per m².
Set contents:
1x Stonefix injection adhesive 2K tube 195 ml. (single tube)
1x Cobalt drill bit 2 mm.
2x Stonefix End tips
1x Stonefix Mixing tip for 195 ml. tubes
1x User manual
Usage:
For tiles glued (best double glued) with tile adhesive, usage is between 1 and 2½ litres of injection adhesive per m².
For tiles laid in cement/mortar, usage is between 3-5 litres injection adhesive per m².
Deliverable: as a set
| Graduated prices | |
|---|---|
| Quantity | Price per piece |
| 1 or more | € 39,91 |
| 6 or more | € 36,77 |
| 12 or more (1 carton) | € 35,41 |
| 60 or more (5 cartons) | € 34,83 |
Social media